Yuneec CGO3+ Mount Set for the Typhoon H YUNCGO3P105

Q: Does this come with the pins and locks to prevent the camera from falling off?

Asked by: Doug Gleason - 7/13/2016

A: Yes. It now includes the plastic pins.

Was this answer helpful? 6 of 9 Customer(s) found this Answer helpful.

Answer provided by: Andrew (8/3/2016)

Q: I see whats wrong, the base plate is the part that need, the part that slides on the drone broke the slides I need the the base plate, when I crashed it broke the slides that attach it to the drone, I'm looking at the base plate on your website, my problem is I can't seem to figure out how the base plate comes away from the wiring and contacts. Is this something I can do without taking it in for repairs? So far I've got the washers off the two pins, haven't gotten any farther in the last hour. Any help with this would be appreciated. The drone is a Typhoon H with a CGO3 +

Asked by: Paul Couture - 5/11/2017

A: Hello Paul,

If you are looking to swap out your mountset for the CGO3+, you will need to remove the three silver screws that are holding the contact plate in its place, once you loosen this panel, the contact plate and wiring can be separated from the top dampening plate and swapped out

Was this answer helpful? 5 of 7 Customer(s) found this Answer helpful.

Answer provided by: Spencer (5/16/2017)

Q: Is there 4 pins or just 2 that hold the camera bracket together because mine only has 2 I just bought new?

Asked by: REX DICKEY - 5/16/2017

A: Hello SIr,

Only two pins are needed to secure the slip ring wires from damage, each on an opposite corner

Was this answer helpful? 4 of 7 Customer(s) found this Answer helpful.

Answer provided by: Spencer (5/17/2017)

Q: Can you just purchase the retaining pins? My mount is fine, I just need the washers the lock the pin in place.

Asked by: Mark - 8/7/2017

A: We are working with Yuneec to make the pins available. Please check back in the near future for availability.

Was this answer helpful? 4 of 6 Customer(s) found this Answer helpful.

Answer provided by: Andrew (8/11/2017)

Q: the picture only shows 2 of the 4 retaining pins is that all this comes with? I am in need of 4 pins and the clips.

Asked by: Casey Owens - 3/1/2019

A: The mount set only comes with two, because it is only suggested to have two retaining pins one on each side diagonally. We do not sell the retaining clips separately, they only come with the mount set.

Was this answer helpful? 4 of 6 Customer(s) found this Answer helpful.

Answer provided by: Amanda Saul (3/1/2019)

Q: bought typhoon h , only two of 4 mounts are connected, is this normal?

Asked by: j - 3/11/2017

A: Yes, this is how they are shipped from the factory. Two is sufficient to prevent wire damage in the even of a hard landing.

Was this answer helpful? 3 of 4 Customer(s) found this Answer helpful.

Answer provided by: Andrew (3/20/2017)

Q: Is there 4 of the pins and the washer clips with this kit ?

Asked by: Earl Mannette - 10/23/2017

A: This kit comes with 2 pins and 2 washer clips.

Was this answer helpful? 3 of 6 Customer(s) found this Answer helpful.

Answer provided by: Amanda Saul (3/15/2018)

Q: Will this fit my Typhoon QS 500 4K ? It looks the same other than another contact window. Thanks

Asked by: David Martin - 2/3/2021

A: Unfortunately this will not fit the Q500 since the mount is slightly different.

Was this answer helpful? 2 of 4 Customer(s) found this Answer helpful.

Answer provided by: Amanda Saul (5/11/2021)

Q: Will this mount fit the Yuneec typhoon Q500+ ?

Asked by: hightv - 7/5/2017

A: No. The mount set you are looking for can be found at the following link: https://www.vertigodrones.com/Yuneec-Mount-Set-CGO3_p_183.html

Was this answer helpful? 1 of 3 Customer(s) found this Answer helpful.

Answer provided by: Andrew (8/6/2017)

Questions about this item? Ask here.

Yuneec H850 Series Motor Frame PCB Light YUNH850118SVC

(0)

$6.99

In Stock

Yuneec H850 Series Thermal Conductivity Silicon Pad Set YUNH850140SVC

(0)

$14.99

In Stock

Yuneec H850 Series Top Portion of Standard Gimbal Mount YUNH850145SVC

(0)

$69.99

In Stock

Yuneec H850 Series Gimbal Connection Board YUNH850147SVC

(0)

$14.99

In Stock

Yuneec H850 Series Payload Release System (YUNLRD)

(0)

$1,089.99

In Stock

DJI Inspire 3 TB51 Intelligent Battery (CP.IN.00000029.01)

(0)

$349.00

Backorder

Zenmuse P1 45MP Full-Frame Photogrammetry Camera with Shield Plus

(0)

$6,800.00

In Stock

DJI Mini 4 Pro Fly More Combo with RC 2 Controller (CP.MA.00000735.01)

(0)

$1,099.00

In Stock

DJI Mini 4 Pro Intelligent Flight Battery (CP.MA.00000756.01)

(0)

$65.00

In Stock

Autel Titan

(0)

$42,859.00

Preorder

DJI FPV Remote Controller 3 (CP.RC.00000024.01)

Select Options

(0)

$199.00

In Stock

Yuneec H600 RTK (YUNH600-RTKUS)

(0)

$4,599.00

Preorder