Yuneec CGO3/CGO3+ Camera Housing (Rear / Front Ball)

You will need to transfer the clear plastic light director for the LED lamp from your old unit. Be sure to save that. Otherwise all the screws and parts are included.

This part will make your camera just like new. Install using only a small phillips head screwdriver. Be sure to buy the decal set so you can replace the chrome 4K on the front of the camera

fit perfectly, included all the tiny screws needed to hold it together.

They were just what i needed to repair camera housing

As easy as it seemed, this replacement part had a couple issues, none which kept it from working. The reason you would buy one of these is because of a crash or damage. My camera worked fine but had a broken ball. Putting on the new one, the front piece that snaps around the lens would not fit or snap into the slots. Something had moved internally but couldn't tell what or see any visible damage. It required slightly enlarging the slots that the tabs on the camera cover snapped into, and then it worked. This version also didn't have the chrome plated "4K" logo, but just had "4K" molded into the plastic. The clear LED piece that directs light into a tiny hole at the front is not included with this cover. You'll need to reuse your old one, unless it has also broken. That should have been part of the included parts but wasn't. They did include a new set of screws which was handy and fit perfectly.